I absolutely loved the most recent box from Makerly! I haven’t done any work with beads and wire wrapping for ages and it was so nice to spend time doing one of my first hobbies on such a beautiful project, the Sunburst Sun Catcher.
Included in the box was:
- 25cm metal hoop
- 8cm metal hoop
- Glass seed beads (red, orange, and yellow)
- Mixed acrylic beads (red, orange, and yellow)
- 4cm sun catcher crystal
- 0.4mm jewellery wire
- Glue dots
The first step was to anchor the smaller hoop to the larger one with the wire and then create the first ‘ray’ of the sunburst from the top of the smaller hoop up to the centre point at the top of the larger hoop to hold everything in place. I was surprised at how effective the glue dots were at holding the wire in place. I thought the wrapping would be enough, but it was quite a fine gauge and the glue dots were a definite must to keep each ray where it was meant to be. Despite the fine gauge of the wire I found the snips a bit useless for cutting through it. I would normally use these kind of snips for yarn or thread and proper wire cutters were much better for the job. They did get through the wire, but not cleanly in one go like wire cutters would.
The rays were left loose on the hoops until all of the beads had been strung on each one and then there were secured with the glue dots, allowing them to be positioned evenly around the hoop to create the sunburst design. I followed the design in the picture, alternating rays of larger beads and seed beads and graduating from yellow in the centre through orange to red at the edges, but there was plenty of scope in this kit to use the beads to create any design you liked.
The last thing to do was to secure the crystal in the centre of the small hoop and create a wire hook at the top of the sun catcher so it can be hung in the window. This kit was really straightforward to complete and didn’t take long to do at all. I’m so pleased with my finished sun catcher and I can’t wait for the rainbows to come pouring into my house!